starter clutch replaced -clutch pusher rod not seating?
replaced starter one way clutch. pulled clutch rod to apply oil . after locking down cover went to use screw driver to lift lever to attach cable. seems to be too hard pushing in with lever
checked manual to see if push rod end had washers or sbearings. not good shots. anyone have info???
does the end of pusher on right side have bearing washers that woud drop blocking pusher rod?
how about the length -extension- of pusher rod from back wall ?
i do not want to lock her up, add oil and then have to open right case & dissaemble clutch if there is any way to figutre it out.
thanks in advance