Does anyone know if there is a mod that would allow replacing the heel toe shift with a toe only shift? I really would like to keep the heel toe shift in case I decide to sell the bike down the road so I would rather not cut it. I also would like to bring the shifter back about an inch or so. Any suggestions? Thanks in advance for any advice.
950 toe only shift?
1 - 4 of 4 Posts
Joined
·
31 Posts
I toe shift on my 1100 with no problems, even wearing boots. Maybe you can adjust it to where you can toe only shift without changing anything.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
V-Star 1300 clutch cable replacement
V StarI'm working with a 2009 Star 1300. I've seen this question asked before but no one ever posts HOW they changed the cable. I know the gas tank needs to be lifted or removed. Does the exhaust need to be removed as well? Looks like it's impossible to get to the engine-side of the cable without...- 4
- 77
-
2007 V-Star 650 idles fine, but bogs down when going through the gears
V StarI just bought this 2007 V-Star 650, which had the carbs in the saddlebags, as the previous owner had giving up. I cleaned and rebuilt the carbs thoroughly and put back together. She started fine, I adjusted the idle screw and decided to go for a quick ride around the block. I noticed my...- 27
- 239
-
Azuqui · updated
-
Bike turning over but will not stay running
V StarHey all, I recently bought an 07 Vstar 650 with around 7k miles and when I went to buy it the bike started perfectly but when I got home it had trouble staying running. The bike turns over and stays going with the choke fully out but it dies after 30 seconds or so. However if I start it up and...- 12
- 152
-
Ruby's Build thread
V StarNew to the forum so not sure if this is a thing on here, but wanted to make a build thread for my bike! I'm on other forums for my truck and there are build threads on there (so of course I have one for my truck haha), and figured I'd do the same here for the bike, so if this is not allowed I...- 10
- 335
-
Themike1220 · updated
-
expose bass "nipple" by carburetors
V StarPuzzled here... Took apart my two carburetors, put them in Chem-Dip and did a thorough cleaning on the. Reinstalled them and as soon as I open the petcock, get a gasoline leak. I feel pretty sure I re-installed all the hoses. But there is a naked brass nipple at the bottom of one of the carbs...- 1
- 38
-
bctrembley44 · updated
Join now to ask and comment!