Yamaha Starbike Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I recently purchased a cobra fuel processor for my 12 Stryker 1300, I already have a cobra intake with the high flow K&N intake, I added Pacific Coast Star drag pipes/headers, can anyone suggest what settings I need to dial in on the 3 pots in the fuel processor

94024
 

·
Administrator
Joined
·
15,618 Posts
i have a cobra processor for the 950 so my settings would probably not apply to you. but even among 950 owners with the same cobra processor there are tons of different settings out there people are using. my advice is to start low, like 1/1/1 and then run through a tank of gas. then in crease each pot by a single digit on another tank of gas and then basically stop or go back one on a particular pot when you think you've hit your sweet spot. the settings on my 950 right now are somewhere around 1/2/2
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top