Yamaha Starbike Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter · #1 ·
Has anyone installed a Freedom Performance slip on exhaust? Got one that said it was for the Bolt, but of course it didn't come with instructions, and I can't find anything online. Freedoms website is useless as well.

I got it figures out for the most part. But the pipe only goes on so far and then stops. None of the mounting weld tabs line up. The original exhaust seal does not fit inside it either. I'm pretty much lost at this point. Any help is welcome.

Thanks in advance!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top