Yamaha Starbike Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
I just installed a Pro-One Tach Kit with 4" risers and the tach is not reading. I installed it to the right side coil as per instructed and it is still not reading. The red and blue wire is connected to the red/black coil wire and the green wire is connected to the orange coil wire and the black wire is grounded. I know that the ground is good since the back light is lit. When I start the bike, it reads either below 0 RPM's or up to 0, but never goes over....Any suggestions?
 

·
Registered
Joined
·
410 Posts
Sometimes there is a switch on the back of the tach for setting the # of cylinders. Make sure it is set to 2. and check your wiring. if all is good could be just a bad tach. It happens.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #4
Thanks

Thank you for the replies, it appears that it is a bad tach and the manufacturer is sending me a new one.
 
1 - 4 of 4 Posts
Top